Foamed Silicone

Foamed Silicone is an expert in creating bulging three - dimensional patterns on fabrics. It has an excellent foaming effect, and the printed patterns are as fluffy as small bread, with a dry and non - sticky hand feel. Most importantly, it can foam at a relatively low temperature. For heat - sensitive fabrics such as silk and thin cotton, there is no need to worry about them being damaged by heat. Foamed Silicone thickens quickly, and the required thickness can be achieved in one printing, eliminating the need for repeated overprinting, thus saving materials and time. The operation time is also long, allowing workers to slowly adjust the foaming range without worrying about premature curing. Even if too much is prepared, the remaining can be reused in a short time, resulting in less waste. When using Foamed Silicone, it should be combined with ultra - high - density silicone. Add more to make the foam higher, and add less to make it lower, which is very flexible. Selecting a 100 - 120 - mesh screen can ensure uniform foaming. Drying at 120 - 150°C can not only make the foam set quickly but also prevent the fabric from deforming. The printed three - dimensional patterns are beautiful and firm, and will not collapse after washing.

The most prominent advantage is Foamed Silicone's good foaming effect, which can create fluffy three - dimensional patterns. The low - temperature foaming is suitable for heat - sensitive fabrics, solving the problem of three - dimensional printing on sensitive fabrics. Foamed Silicone thickens quickly, and one - time printing meets the standard, eliminating repeated overprinting, saving time and materials, and improving efficiency. The long operation time gives workers sufficient time to adjust the foaming range, reducing the operation difficulty. The foam height can be flexibly adjusted by combining it with ultra - high - density silicone to meet different needs. The 100 - 120 - mesh screen ensures uniform foaming, and the drying temperature of 120 - 150°C is reasonable. The foam sets quickly without damaging the fabric, and the patterns are firm, wash - resistant, and do not collapse. Foamed Silicone is an ideal material for three - dimensional pattern printing.

1. Use an electronic scale, take an appropriate amount of Foamed Silicone, add it to the mixture with a ratio of 10% (or 2%) using Curing Catalyst, and add an appropriate amount of Liquid Silicone Rubber Thinner according to the printing requirements, stir evenly.

2. Pour the prepared silicone mixture into the mesh plate and use a scraper to apply it.

3. First, use the prepared transparent right-angled silicone to print thickly for 3 - 4 times. Wait for it to dry after each print before the next print.

4. Then, use Foamed Silicone to print for 3 - 4 times. Wait for it to dry after each print before the next print (control the tabletop temperature below 80 degrees).

5. Put it into the tunnel furnace and bake for 10 - 30 seconds.

Hot Tags: foamed silicone, China foamed silicone manufacturers, suppliers, factory